Morfe LED with Fulham Driver - Fittings: "Morfe LED Module" Driver: L1E1230070S-12E


350mA Warm White fitting with 12W max driver

Main Image

Test Date: 07/02/2018

Dimming Performance

RMT500/RAK4-T: Minimum brightness from off: 10% Minimum brightness from max: 10% RML500: Minimum brightness from off: 20% Minimum brightness from max: 20%

Smoothness of Dimming

This lamp dimmed smoothly in the upper section of its output range but experienced considerable issues when dimmed to a low level. Towards the bottom end of the output range, the lamp flickered and shimmered very noticeably while fading. While some shimmer while fading was seen towards the upper end of the output range it was less obvious. The profile, in general, was smooth and continuous.

Audible Noise

No audible noise when tested with any dimmer.


The result stated is for 9 LEDs wired in series from a signal driver. The stated "tested units" refers to the number of drivers tested. The "Minimum Brightness" is the minimum point where the lamp is not flickering.

Rating for module compatibility

Dimmer Ratings
Dimmer Rating Tested Units Probable Max Units
RMT-500 Neutral 1 12
RML-500 Not Recommended 1 8
RAK4-T Neutral 1 20
WMT-400 Not Tested - -


Scope #1


Scope #2


Scope #3